https://www.high-endrolex.com/10

 7th Balkan Mining Congress - confOrganiser.com

7th Balkan Mining Congress

October 11 - 13, 2017.

DETERMINATION OF STRAIN RATE STATE AT FORGING IN OPEN DIE

Author(s):
1. Mileta Janjić, University of Montenegro, Faculty of Mechanical Engineering, Podgorica, Montenegro
2. Sreten Savicevic, University of Montenegro, Faculty of Mechanical Engineering, Podgorica, Montenegro
3. Milan Vukcevic, University of Montenegro, Faculty of Mechanical Engineering, Podgorica, Montenegro


Abstract:
Kinematic state of a working-piece at bulk metal forming of axialsymmetrical pieces has been determined in this paper. Strain rate tensor components are determined by the known theory, as partial strain rate component devivations. Displacement rate points of meridial section are basic for kinematic state determination. As non-stationary deformation process is concerned, it is necessary to determine initial and final points displacements when a relatively short observed interval is constant. Point displacements are determined by known geometry of groovelike plates before deformation and measured coordinate points out of digitalized picture of meridial section after deformation. Measure meuts are done by setting the lines with sufficient number of points. At the end, a graphic interpretation of the obtained results is given, their analysis and conclusions are made.

Key words:
Bulk Metal Forming,Open Die,Finite Element Method (FEM),Deformation,Strain,Strain Rate,Displacement,Displacement Rate,Forming Velocity.

Thematic field:
Production Technologies and Engineering

Date of abstract submission:
26.03.2015.

Conference:
DEMI 2013

  • Login
  • Language
Copyright © 2021 confOrganiser.com. All rights reserved. | BitLab

https://www.high-endrolex.com/10